Figure 3-4: Bottom Cover Retention Screws; Figure 3-5: Hdd Bracket Retention Screws - IEI Technology S19A/S24A-QM87i User Manual

Step 2: Remove the bottom cover of the SBOX by removing the 11 retention screws on
the bottom panel. See Figure 3-4.

Figure 3-4: Bottom Cover Retention Screws

Step 3: Locate the HDD brackets inside the bottom cover. Remove the four HDD
bracket retention screws of one of the HDD brackets and lift the HDD bracket.

Figure 3-5: HDD Bracket Retention Screws

Step 4: Insert an HDD into the bracket until the HDD is firmly connected with the SATA
cable connector. Secure the HDD to the bracket using four retention screws (two
screws on each side). See Figure 3-6.
Page 20
S19A/S24A-QM87i Marine Panel PC