Gl300W Manage Tool Interface; System Requirements - Queclink GL300W User Manual

GL300W Manage Tool User Guide

2. GL300W Manage Tool Interface

GL300W manage tool is PC software which can be used to configure GL300W through
Data_Cable_M or USB Cable. It is easy for the backend server developers to configure GL300W
with manage tool, which has friendly user interface. The correct command messages sent to
GL300W will be displayed on the manage tool. (These messages can also be sent by SMS or
UMTS ).
The administrators can also use the manage tool to configure GL300W before selling. But it is
strongly recommended to establish a backend server and implement the way to control GL300W
by SMS or UMTS. Please refer to "GL300W @Tracker Air Interface Protocol" for detail.
Before using the manage tools please find "Queclink_WCDMA_USBDriver_V1.00" in develop suit
and install the driver. After that a new COM port can be found in the PC system, and then please
follow the steps as below:
1. Power on GL300W.
2. Connect GL300W to PC with USB Cable or DATA_CABLE_M.
3. Run "Queclink GL300W_Manage_Tool_Vx.xx.exe".

2.1. System Requirements

In order for this manage tool to run on your computer, you must use it in below operating
system:
♦
Windows 98SE;
♦
Windows ME Windows 2000 SP4;
♦
Windows XP SP2 and above (32 & 64 bit);
♦
Windows Server 2003 (32 & 64 bit);
♦
Windows Server 2008 (32 & 64 bit);
♦
Windows Vista (32 & 64 bit);
♦
Windows 7 (32 & 64 bit);
♦
Windows 8 (32 & 64 bit);
Supported System Environments:
♦ Microsoft .NET Framework 2.0 or higher
TRACGL300WMT001
- 4 -