Emerson Rosemount 3812 Maintenance And Troubleshooting Manual page 122

Meter maintenance
April 2022
Figure 3-82: Shroud security seals
A. Top end shroud
B. Security wire seals
Procedure
1. Install the security seal wire into and through the two bolt holes on the top end
2. Remove all slack and seal.
3. Repeat previous step for the other top end shroud.
4. Cut wire ends to remove excess wire.
Split shroud security seals
Use the following instructions to install the security seal wires on the split shroud covering
the meter body and transducer assemblies.
122
shrouds (maximum wire diameter .078 inch; 2.0 mm). Position the wire to prevent
counterclockwise rotation of the screws when the seal wire is taut.
This completes the clamped band shroud security seal installation procedure.
Maintenance and Troubleshooting Manual
Emerson.com/Rosemount
00809-0100-3812