Table of Contents
Advertisement
Assign ATM Transmit Priority
Mark IP Precedence
IP Type Of Service
Assign Differentiated Services
Code Point (DSCP) Mark
Mark 802.1p if 802.1q is
enabled on WAN
Specify Traffic Classification Rules
Enter the following conditions either for physical LAN/Wireless port or for IP level,
SET-1, or for IEEE 802.1p, SET-2
SET-1
Physical LAN Port
Protocol
Select Low, Medium or High.
Select between 0-7. The lower the digit shows the
higher the priority
If non-blank value is selected for 'Mark IP
Precedence' and/or 'Mark IP Type Of Service', the
corresponding TOS byte in the IP header of the
upstream packet is overwritten by the selected
value.
Note: If Differentiated Service Configuration
checkbox is selected, you will only need to assign
ATM priority. IP Precedence will not be used for
classification. IP TOS byte will be used for DSCP
mark.
Select either: Normal Service, Minimize Cost,
Maximize Reliability, Maximize Throughput,
Minimize Delay
If non-blank value is selected for 'Mark IP
Precedence' and/or 'Mark IP Type Of Service', the
corresponding TOS byte in the IP header of the
upstream packet is overwritten by the selected
value.
Note: If Differentiated Service Configuration
checkbox is selected, you will only need to assign
ATM priority. IP Precedence will not be used for
classification. IP TOS byte will be used for DSCP
mark.
Choose the required DSCP value. Default value is
"000000".
Select between 0-7.
User can select from: ENET, ENET(1-4), USB,
Wireless or Wireless_Guest.
User can select from: TCP, TCP/UDP, UDP or ICMP.
67
Advertisement
Table of Contents
