Table of Contents
Advertisement
Chapter 8 Diagnostics
The Diagnostics menu provides feedback on the connection status of the CT-5372
and the ADSL link. The individual tests are listed below. If a test displays a fail
status, click Rerun Diagnostic Tests at the bottom of this page to make sure the
fail status is consistent. If the test continues to fail, click Help and follow the
troubleshooting procedures.
Test
Ethernet Connection Pass: indicates that the Ethernet interface from your
USB
ADSL
Synchronization
Description
computer is connected to the LAN port of your DSL Router. A
blinking or solid green LAN LED on the router also signifies
that an Ethernet connection is present and that this test is
successful.
Fail: Indicates that the DSL Router does not detect the
Ethernet interface on your computer.
This option is for future release.
Pass: Indicates that the DSL modem has detected a DSL
signal from the telephone company. A solid WAN LED on the
router also indicates the detection of a DSL signal from the
telephone company.
Fail: indicates that the DSL modem does not detect a signal
from the telephone company's DSL network. The WAN LED
will stop blinking (i.e. training) and the LED will stop
illuminating (i.e. go blank).
103
Advertisement
Table of Contents
