Table of Contents
Advertisement
2.
Filter Name
Protocol
Source Address
Source Subnet Mask
Source Port
Dest. Address
Dest. Sub. Mask
Dest. Port
This rule will ACCEPT all UDP packets coming from WAN interface
mer_0_35/nas_0_35 with IP Address/Sub.Mask 210.168.219.45/16 and a
source port in the range of 5060 to 6060, destined to 192.168.1.45/24 and a
destination port in the range of 6060 to 7070. All other incoming packets on this
interface are DROPPED.
MAC Layer Filtering:
These rules help in the filtering of traffic at the Layer 2. MAC Filtering is only
effective on ATM PVCs configured in Bridge mode. After a Bridge mode PVC is
created, navigate to Advanced Setup -> Security -> MAC Filtering web page.
Global Policy:
When set to Forwarded the default filter behavior is to
Forward all MAC layer frames except those explicitly stated in the rules.
Setting it to Blocked changes the default filter behavior to Drop all
MAC layer frames except those explicitly stated in the rules.
To setup a rule:
Protocol Type: Can be either PPPoE, IPv4, IPv6, AppleTalk, IPX, NetBEUI, IGMP.
Destination MAC Address: Of the form, XX:XX:XX:XX:XX:XX. Frames with
this particular destination address will be Forwarded/Dropped depending on
whether the Global Policy is Blocked/Forwarded.
: In_Filter2
: UDP
: 210.168.219.45
: 255.255.0.0
: 5060:6060
:192.168.1.45
: 255.255.255.0
: 6060:7070
130
Advertisement
Table of Contents
