Advertisement
UNPACKING & SET-UP
Your new preamplifier has been carefully wrapped in heavy gauge plastic, packed in semi-rigid
foam and contained in a special box. To remove the unit, open and spread the top flaps of the box. By
its sides, lift out the entire unit with the foam pieces intact. Remove each foam side by pulling straight
out. Remove the plastic wrap and inspect the unit for any concealed damage. Apart from this owner's
manual, please ensure the following has also been included:
1) External power supply.
2) Detachable A.C. linecord.
3) Detachable D.C. power supply cable.
4) 5/64 in. Allen key for top cover
5) Remote Control unit (Allen key and Batteries AAA X 2 included).
Please report any damage or missing parts to your dealer promptly.
This preamplifier, being capable of very high gain, must be located in a position free of any
hum-inducing magnetic fields. (This also applies to turntables and interconnect cables.) Positions
adjacent to power amplifiers, A.C. line filters, or regulation devices should be avoided. Ideally, a few
feet should separate the preamplifier from the power amplifier. As well, keep low-level interconnect
cables away from the power amp and separate from A.C. linecords.
Heat generated by the preamplifier is negligible. Air space around the unit need not be a
concern.
Check the Serial Number sticker on the back of the unit for the correct operating voltage.
Regardless of voltage, the fuse rating should be 2 AMP SLO-BLO.
-4-
Advertisement
