(5) Adjusting the amount of slack
Perform the following adjustment if the leading edge of the copy image is missing or varies randomly, or if the copy paper is
Z-folded.
Procedure
Enter maintenance mode.
Run maintenance item U051.
Select "FEED DATA."
Press the interrupt key.
Press the start key to make a
test copy.
edge of the image missing
or varying randomly
(copy example 1)?
(copy example 2)?
Exit maintenance mode.
Start
Select "LCF."
Is the leading
No
Is the copy
paper Z-folded
No
End
Original
Press the start key.
Yes
Increase the value using the cursor
upper key.
Yes
Decrease the value using the cursor
lower key.
Setting range: 0 – 255
Changing the value by 1 changes the
amount of slack by 0.67 mm
Reference: 0
The greater the value, the larger the
amount of slack;
The smaller the value, the smaller the
amount of slack.
Copy
example 1
Figure 1-4-6
The new setting is stored.
5FF
Copy
example 2
1-4-5