Kyocera AD-63 Service Manual page 486

Code
C1130 Deck left lift position problem
Deck level switch 2 does not turn on
within 30 s of paper deck motor 2 turn-
ing on.
C1160 Sequence problem
C1170 Large paper deck incorrect type
problem
C2600 Deck paper conveying motor prob-
lem
No pulse is input within 500 ms of the
start-up.
No pulse is input within 100 ms of the
previous pulse input.
Contents
Causes Check procedures/corrective measures
Defective paper Check for continuity across the coil. If
deck motor 1. none, replace paper desk motor 1.
Poor contact of Reinsert the connector. Also check for con-
paper deck motor tinuity within the connector cable. If none,
1 connector termi- repair or replace the cable.
nals.
The deck left lift Check the gears and belts, and remedy if
does not rise necessary.
properly.
Operation start Turn the power off and back on (reset re-
request is sent quest is sent from the copier to the large
from the copier to paper deck to cancel operation start
the large paper request).
deck while paper
feed is disabled.
Paper feed re- Turn the power off and back on (reset re-
quest is sent from quest is sent from the copier to the large
the copier to the paper deck to cancel operation start re-
large paper deck quest).
before operation
start request.
Deck for the Replace the deck fot the copier.
printer is installed.
Defective deck Replace the deck conveying motor PCB
conveying motor and check for correct operation.
PCB.
Deck conveying Check the gears and remedy if necessary.
motor does not
rotate correctly
(the motor is over-
loaded).
Poor contact in Reinsert the connector. Also check for con-
the deck convey- tinuity within the connector cable. If none,
ing motor connec- remedy or replace the cable.
tor terminals.
Remarks
5FF
1-3-7