Kyocera AD-63 Service Manual page 86

4. Remove the tape securing the solenoid, and
the tape securing the shifting guide.
5. Set the waste punch box back into the
finisher, and fasten it into place with the two
fastening pins.
6. Pull the rail unit out of the finisher.
7. Loosely fasten the rail unit to the copier's
finisher-attachment area with the two M4 × 10
TP-A bronze screws.
8. Move the finisher next to the copier, and open the finisher's front cover. Adjust the height-adjustment screw in the rail
unit until the guideline marked on the retainer is aligned with the center of the height-adjustment plate.
Height-adjustment
plate
M4 × 10
TP-A bronze screws
Height-adjustment
Guideline
Figure 1-3-158
2FD/2FF/2FG
Solenoid
Tape
Tape
Shifting guide
Figure 1-3-156
Rail unit
Figure 1-3-157
screw
Rail unit
1-3-65