Fargo HDP100 User Manual page 59

RESTRICTED USE ONLY
General Troubleshooting Guide (continued)
Problem
Dash Lines on Image Check the Transfer Roller (D880146) or Platen Roller (D860022)
Film Sensor Error
Ribbon Sticking to
the Film
HDP100 High Definition Card Printer/Encoder User Guide (Rev. Beta)
Possible Solution
for cuts or nicks.
Verify the Film Sensors (J35 and J36) have not been switched.
CHECK FOR ACCURACY
Verify the Take-up Motor turns without delay when Lamination
begins. Increase the transfer tension if the Motor delays.
Verify that the washers (760386) are between the e-clip and
springs on the spring loaded film and Ribbon hubs.
Verify the film is not telescoped on the roll with fixture TL1574.
Verify the Platen Roller stepper Motor cable (D860120) is wired
correctly and is connected to the Motor (E000062) and the
circuit Board (A000300) J32.
Increase the Ribbon Tension. See the
Tension procedure.
Fargo Electronics, Inc.
Adjusting the Ribbon
Continued on the next page
18