Reviewing The Lamination Module Sequence Of Operations - Fargo HDP100 User Manual

RESTRICTED USE ONLY

Reviewing the Lamination Module Sequence of Operations

(Should this entire section be removed and added to the SEALS user manual or is the
Armstrong+flipper+SEALS to be contained in one all-inclusive manual?)
The LAM sequence of operations begins after printing has occurred with the Card Printer.
Step Process
1 The card is fed onto the Lamination Module Flipper Table.
2 The card is fed to the Card Position Sensor.
3 The Lamination Ribbon Motor begins cycling until the Lamination Sensor detects
the mark.
4 The Card Feed Motor activates to center the card on the Platen Roller.
5 The Transfer Roller Lift Motor cycles until the Transfer Roller Lift Sensor detects
state change.
HDP100 High Definition Card Printer/Encoder User Guide (Rev. Beta)
Fargo Electronics, Inc.
Continued on the next page
8