Table of Contents
Advertisement
RRU5303
Installation Guide
Figure 7-44 Disassembling the RRU mounting kits
(1) Main
bracket
(5) Flat washer
1.
2.
Step 2 Install the RRU main bracket using the M10x50 bolts delivered with the IFS06. Then tighten
the bolts using an M10 torque socket to 30 N· m (265.52 lbf· in.).
Ensure that the arrows on the pole mounting kits are pointing up.
Install the RRU mounting kits, as shown in Figure 7-45.
Issue Draft B (2018-05-15)
(2) Square-neck
bolt
(6) Spring washer
Use an M6 inner hexagon torque screwdriver to remove the four inner hexagon screws
on the pole installation bracket, and remove the main bracket from the pole installation
bracket.
Use an M10 torque wrench to loosen the nuts on the two square-neck bolts, and remove
the plastic screw cap, nuts, spring washers, flat washers, square-neck bolts, and pole
installation bracket from the auxiliary bracket.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
(3) Pole installation
bracket
(7) Nut
7 Installing the RRU
(4) Auxiliary
bracket
(8) Plastic screw
cap
80
Advertisement
Table of Contents
