Engaging The Mower; Mowing - Progressive Turf Equipment TD92 Operator's Manual

ENGAGING THE MOWER

When engaging the mower, it is important to follow this procedure:
1) Lower the decks into the working position.
2) Ensure all deck cylinders are FULLY EXTENDED during mowing
(pins should be in center of slot on wings).
3) Set the tractor engine speed at 1000 rpm maximum.
4) Ensure that everyone is clear of the mower.
5) Engage the tractor PTO clutch.
6) Select the proper ground speed gear and slowly engage the
tractor ground drive.
7) Once the mower has come up to speed, slowly increase the
tractor throttle to desired rpm.

MOWING

The TD92 mower is a very versatile cutting machine that allows the
operator to maintain turf on undulating terrain in a productive manner.
Drive safely, cut safely. Be sure to idle the tractor back before
engaging the PTO, and shut the tractor off before leaving the tractor.
NOTE: Under normal cutting conditions, it may be desirable to
operate the tractor at less than 540 rpm PTO speed, reducing
fuel consumption and the noise level. Select a suitable
ground speed gear to maintain proper cutting
OPERATING ON HILLY TERRAIN
When operating on hilly terrain, proceed with caution and drive
carefully. If the tractor has four wheel drive, make sure it is engaged.
On two wheel drive tractors equipped with a differential lock, apply
while driving straight on the hills, disengage to allow for normal turning.
Use care while turning on hillsides in wet conditions. The weight
of the mower behind the tractor may push the tractor
unexpectedly.
.
TD92 Operator's Manual
27