Mounting The Camera With Pole Mount (Accessory) - Mobotix M25-Body Manual

71
/136

Mounting the Camera with Pole Mount (Accessory)

2.4 Mounting the Camera with Pole Mount (Accessory)
If you are intending to mount the camera on a pole, you should consider using the MOBOTIX
M25M Pole Mount. This mount is made of 3 mm powder-coated stainless steel (white)
and has been designed specifically for outdoor use. The supplied stainless steel straps
allow attaching the mount to poles with diameters between 60 and 180 mm (2.4 to 7.1 in).
By design, the Pole Mount does not allow using a flush-mounted wall outlet. In order to
ensure a weatherproof connection of the network devices, it is recommended to use an
MX-Overvoltage-Protection-Box, which is easily installed in the cavity of the VarioFlex wall
mount. For additional information on the MX-Overvoltage-Protection-Box, open the
Products > Accessories > Interface Boxes on www.mobotix.com.
The camera is always installed together with the VarioFlex
mount, which has been prepared at the factory for wall
mounting and which is easily attached to the Pole Mount.
The best camera position for the selected lens must be
found before installing the camera (see Section 2.1,
«Preparing the Installation» ). Once the camera has been
mounted to the pole, you can fine-tune its position.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com