Install The Server In A Rack; Figure 3-3 Installing The Server In A Rack - Silicon Graphics Rackable C2112-4RP9 User Manual

Install the Server in a Rack

!
007-5926-002
Warning:
The SGI Rackable C2112-4RP9 server weighs 85 lbs (38.6 kg). Always use
proper lifting techniques when your move the server. Always get the assistance of another
qualified person when you install the sever in a location above your shoulders. Failure to do
so may result in serious personal injury or damage to the equipment.
You should now have rails attached to both the server chassis and the rack unit. The next step is
to install the server into the rack (refer to
1. Extend the outer rails as shown in
2. Align the inner rails of the chassis with the outer rails on the rack.
3. Slide the inner rails into the outer rails, keeping the pressure even on both sides. When the
chassis has been pushed completely into the rack, it should click into the locked position.
4. Optional screws may be used to secure the to hold the front of the chassis to the rack.
Figure 3-3 Installing the Server in a Rack
Note: The figure above is for illustration purposes. Always install servers to the rack in a
bottom-to-top fashion.
Figure 3-3).
Figure 3-3.
Install the System into a Rack
21