Installing The Optical Drive Cage Or Tape Drive - Dell E30S002 Manual

Figure 35. Removing the optical drive cage or tape drive
Next step
Install the optical drive cage or tape drive.
Related link

Installing the optical drive cage or tape drive

Installing the front bezel
Removing the front bezel
Installing the optical drive cage or tape drive
Prerequisite
NOTE: The procedure to install the optical drive cage is the same as installing the tape drive.
Follow the safety guidelines listed in
Steps
1 Unpack and prepare the drive for installation.
For instructions, see the documentation that shipped with the drive.
If you are installing a SAS tape drive, you must have an internal tape adapter installed. For more information on installing a SAS tape
drive, see the Installing an expansion card
2 If applicable, remove the existing drive or the drive blank.
3 Align the guide on the drive with the slot on drive bay.
4 Slide the drive into the slot until the latch clicks into place.
5 Connect the power and data cable to the drive.
6 Connect the power and data cables to the backplane and the system board.
Safety instructions.
section.
Installation and Service Manual
Installing and removing system components
83