Removing A Memory Module - Dell E30S002 Manual

Processor
Dual CPU (Populate
round robin starting
with CPU1)

Removing a memory module

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the air shroud.
WARNING: Allow the memory modules to cool after you power off the system. Handle the memory modules by the card edges
and avoid touching the components or metallic contacts on the memory module.
CAUTION: To ensure proper system cooling, memory module blanks must be installed in any memory socket that is not occupied.
Remove memory module blanks only if you intend to install memory modules in those sockets.
Steps
1 Locate the appropriate memory module socket.
CAUTION: Handle each memory module only by the card edges, ensuring not to touch the middle of the memory
module or metallic contacts.
2 Push the ejectors outward on both ends of the memory module socket to release the memory module from the socket.
3 Lift and remove the memory module from the system.
Figure 50. Removing a memory module
100 Installation and Service Manual
Installing and removing system components
Configuration
Multi rank sparing population order
Optimized (Independent channel)
population order
Mirroring population order
Single rank sparing population order C1{1}, C2{1}, C1{2}, C2{2}, C1{3},
Multi rank sparing population order
Safety instructions.
Before working inside your
Memory population
1, 2, 3, 4, 5, 6, 7, 8, 9, 10
C1{1}, C2{1}, C1{2}, C2{2}, C1{3},
C2{3}...
C1{1, 2, 3, 4, 5, 6}, C2{1, 2, 3, 4, 5,
6}
C2{3}...
C1{1}, C2{1}, C1{2}, C2{2}, C1{3},
C2{3}...
system.
Memory population information
Populate in this order, odd amount
allowed. Requires three ranks or more
per channel.
Odd amount of DIMM slots per CPU
allowed.
Mirroring is supported with 6 DIMM
slots per CPU.
Populate in this order, odd amount per
CPU allowed. Requires two ranks or
more per channel.
Populate in this order, odd amount per
CPU allowed. Requires three ranks or
more per channel.