Gestetner CS331 Copying Manual page 2

FCC NOTICE
This equipment has been tested and found to comply with limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
WARNING: Changes or modification made to this equipment, not expressly approved by the
supplier or parties authorized by the supplier could void the user's authority to
operate the equipment.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique dela classe A est conforme à la norme NMB-003 du Canada.
Important
Contents of this manual are subject to change without prior notice. In no event will the
company be liable for direct, indirect, special, incidental, or consequential damages as a
result of handling or operating the machine.
Notes:
Some illustrations in this manual might be slightly different from the machine.
Certain options might not be available in some countries. For details, please contact your
local dealer.
Laser Safety:
This machine is considered a CDRH Class 1 laser device, safe for office/EDP use. The
machine contains 4 AIGalnp laser diodes, 30-milliwatt, 680-690 nanometer wavelength for
each emitter. Direct (or indirect reflected) eye contact with the laser beam might cause
serious eye damage. Safety precautions and interlock mechanisms have been designed to
prevent any possible laser beam exposure to the operator.
Caution:
Use of controls or adjustments or performance of procedures other than those specified in
this manual might result in hazardous radiation exposure.
For good copy quality, the supplier recommends that you use genuine toner from the
supplier.
The supplier shall not be responsible for any damage or expense that might result from the
use of parts other than genuine parts from the supplier with your office products.
Power Source
115V, 60Hz, 16A or more
Please be sure to connect the power cord to a power source as above. For details about
power source, see Installation.
Trademarks:
Fiery is a trademark registered in the U.S. Patent and Trademark Office.
Fiery Remote Scan, Command WorkStation are trademarks of Electronics For Imaging, Inc.