10
Reinstall the stapler unit in its previous position and
turn the blue lever 90
unit.
11
Confirm that the finisher is attached to the copier,
and that the paper size is set to any size other
than ST-R.
- Test stapling cannot be performed when only ST-R paper is
available.
12
Close the front cover of the finisher. Test stapling
is then automatically performed on a blank sheet.
- This operation is carried out to avoid empty stapling.
If test stapling fails to be performed and the following
message remains displayed, repeat the above procedure
from steps 1 to 12.
Set staple cartridge
Saddle Stitch Unit (SR940 only)
1
Open the lower cover of the finisher.
o
to the right to latch the stapler
1
2
3
4
5
6
7
8
9
10
11
12
9-21