Table of Contents
Advertisement
DolphinGB-Copy-F_V4_FM.book Page 21 Monday, June 11, 2001 5:02 PM
Before Copying
Before you start copying, specify the original and copy paper locations.
❖ ❖ ❖ ❖ Paper Capacities For Each Original/Paper Output
Original output
Original Output
A1 (D)L or smaller:
(Upper)
• Use originals that are the same size, and
of medium or high quality paper.
• Do not use paper that is long length pa-
per, thick, curled, film, folded, or translu-
cent paper that is less than 80g/m
lb) in weight.
• Do not load more than 10 sheets during
very hot or humid conditions.
• Output thick paper (104.7g/m
or more) to Rear (Straight).
• Translucent paper: 80g/m
less, plain paper: 52.3g/m
less, and originals that are not stiff should
be output to Rear (Straight).
Original Output
A0 (E) or less:
(Rear (Straight))
• A1 (E)KWhen using these types of origi-
nal, the ejected originals may interfere
with the copy paper and impede its
progress. If this happens, use the copy
output (rear) auxiliary guide.
• When using A0 (E) size originals, remove
the originals one at a time.
Document Roller
A1 (D)Lor above:
• Use face-curl originals.
• For roll originals, use originals with a di-
ameter of roll Φ40mm – Φ110mm
(Φ1.6" – Φ4.3").
2. Copying
50 sheets (Plain paper)
20 sheets
(Translucent paper)
2
(27.9lb)
2
(21.3 lb) or
2
(13.9 lb) or
1 sheet (plain paper)
1 sheet (translucent
paper)
1 sheet (film)
1 sheet (Up to 6m
(236")) (plain paper)
1 sheet (Up to 3.6m
(141")) (Translucent
paper)
1 sheet (Up to 3.6m
(141")) (film)
2
(21.3
21
Advertisement
Table of Contents
