Table of Contents
Advertisement
DolphinGB-Copy-F_V4_FM.book Page 36 Monday, June 11, 2001 5:02 PM
Copying
Additional Copy
You can change the copy function set-
tings and make additional copies af-
ter you have finished copying, or
after a copying pause by pressing the
{Clear/Stop} key. When you make ad-
2
ditional copies, the message "To make
an additional copy, press Start key."
appears on the screen.
Limitation
❒ You can change the following
functions when using Additional
Copy.
• Number of copies
• Paper roll selection
• Fine Magnification
• Shift
• Margin
• Border Erase
• Double Copies
• Front output/Rear output
❒ If paper roll was selected as the pa-
per source in the original settings,
you cannot select the bypass tray.
❒ If a function from the optional
Print function was selected in the
original settings, you can change
Print type, if you did not select a
Print function in the original set-
tings, you cannot select them for
Additional Copy.
❒ If Image Repeat was selected in the
original settings, you can change
or delete the setting. If you did not
select the Image Repeat function in
the original settings, you cannot
select it for Additional Copy.
36
A
Check that the message "To make
an additional copy, press Start
key." is displayed on the screen.
B
Add or change function settings.
Important
❒ If you make a mistake entering
the settings, press the function
key again to cancel the settings
or press the {Clear/Stop} key to
cancel the settings. If you press
the {Clear Modes/Energy Saver}
key, you can delete the scanned
image of the o riginal from
memory.
C
Press the {Start} key
ZEDS050E
Advertisement
Table of Contents
