Table of Contents
Advertisement
The Transmission Mode menu ap-
pears.
C
Enter the code for "Transfer Re-
quest" with the number keys.
Note
If the appropriate display is not
shown, press [ Prev.] or [ Next].
D
Enter a Transfer Station and press
[Recv. Stn].
Limitation
You cannot specify a transfer
station and a normal fax desti-
nation at the same time.
Note
Enter the fax numbers of the
Transfer Stations with either
Quick Dials, Speed Dials or the
number keys.
If you make a mistake, press the
{Clear} key or {Stop} key and
try again. The {Clear} key de-
letes one character at a time, and
the {Stop} key deletes the whole
line.
To cancel the Transfer Request,
press[Cancel]. The "Transmis-
sion Mode" menu is shown
again.
E
Enter one or more End Receivers.
Note
You cannot enter the numbers
of the End Receivers directly.
The numbers must be stored in
Quick Dials, Speed Dials or
Groups in the Transfer Sta-
tion(s). To specify an End Re-
ceiver, use the special format
described in
an End Receiver".
Press [Add RcvStn] if you wish
enter more End Receivers.
Press 0 or 1 to see the End Re-
ceivers already entered. You
can select an End Receiver from
this list and cancel it by pressing
the {Stop } key or {Clear} key.
To cancel the Transfer Request,
press [Cancel].
F
When you have specified all the
End Receivers, press [OK].
G
If you want to enter an additional
Transfer Station, press [Enter] and
repeat steps D to F.
If you press [No], the "Transmis-
sion Mode" menu is shown and a
check mark is added to Transfer
Request.
Transfer Request
P.126 "Specifying
125
4
Advertisement
Table of Contents
