Table of Contents
Advertisement
Receiving a Fax Message
How to make a Remote Transfer Request
(push signal)
This procedure describes how to
make a Transfer Rquest to this ma-
chine from the requesting party's ma-
chine.
Note
To
cancel
progress, press the {#} key twice.
3
A
Set your document and adjust any
scan settings as necessary.
B
Dial using On Hook Dial, or lift
the handset and dial.
C
When the connected line is a dial
line, the machine switches over so
it can send a push signal.
D
When you hear the "peeee-pee-
yo-ro-ro-ro" tone, press the {#}
key.
When the remote transfer is ac-
cepted, you will hear a confirma-
tion "peeee" tone.
Note
If remote transfer is turned off
on the machine at the other end,
you will not hear a confirmation
tone and the tone mentioned in
step D will continue.
If the Transfer Rquest is not ac-
cepted, for example if memory
is full or the Remote ID has been
wrongly entered 5 times, you
will hear five "pee-po" tones
and the line will be cut off.
E
Enter the 4-digit Remote ID
stored in the transfer station, then
press the {#} key.
If you enter the wrong ID, you will
hear a "pee pee pee" tone. If this
happens, try again.
94
the
operation
in
Important
If you do not carry out steps E -
J within 30 seconds, the line
will be cut off.
Enter the next tone within 5 sec-
onds. If you wait too long, you
will hear a "pee pee pee" tone
and you must start the whole
procedure again.
If you enter the wrong Remote
ID 5 times, the line will be auto-
matically cut off, and if you do
not change this machine's Re-
mote ID, remote transfer will
not be accepted. The figure of 5
carries over from previous non-
valid attempts.
Note
When you enter the correct ID,
you will hear a "peeee" tone.
F
Press {2}{4}{#}.
G
Press the {p} key 3 times. Speci-
fy the Transfer Result Report re-
turn address stored in the transfer
station using the procedure be-
low, then press the {#} key.
If the return address is correct, you
will hear a "peeee" tone.
Note
If you hear a "pee pee pee" tone,
press the {p} key 3 times and
enter the return address again.
If you keep on getting the error
tone, the return address may
not be registered in the Quick
Dial or Speed Dial you are spec-
ifying.
Advertisement
Table of Contents
