Table of Contents
Advertisement
When the Return Address is
Stored in a Quick Dial
A Enter the number (01-64) of the
Quick Dial.
When the Return Address is
Stored in a Speed Dial
A Press the {p} key, then enter
the Speed Dial code (00-99).
H
Specify the end receiver then
press the {#} key.
If the end receiver is correct, you
will hear a "peeee" tone.
Note
Specify an end receiver that has
been stored in a Quick Dial,
Speed Dial or Group.
If you hear a "pee pee pee pee"
tone, specify the end receiver
again.
If you keep on getting the error
tone, the end receiver may not
be registered in the Quick Dial
or Speed Dial you are specify-
ing.
Specifying the End Receiver with
a Quick Dial
A Enter the number (01-64) of the
Quick Dial.
Specifying the End Receiver with
a Speed Dial
A Press the {p} key, then enter
the Speed Dial code (00-99).
Specifying the End Receiver with
a Group
A Press the {p} key twice, then
enter the Group number (01-
09).
I
Repeat step H for all end receiv-
ers.
Note
If you specify 30 end receivers,
the Transfer Request is accepted
and you will hear a "pee pee pee
pee" tone. In this case, proceed
to step K.
J
Press the {#} key twice.
K
When you hear the "peeee-pee-
yo-ro-ro-ro" tone again, press the
{Start} key.
Your document will be sent.
Remote Transfer with UUI
This function requires the optional G4
unit.
It allows G4 faxes with the UUI fea-
ture to make Transfer Requests to this
machine using UUI instead of a push
signal.
Preparation
You need to store the Tone (UUI)
function in a User Function key be-
forehand.
P.211 "Assigning User
Function Keys"
Limitation
You can specify up to 30 end re-
ceivers with UUI.
Note
You can select whether or not the
machine accepts remote transfers
or not with the User Parameters.
Reception Functions
95
3
Advertisement
Table of Contents
