Table of Contents
Advertisement
To toggle a Scan Listʼs enabled/disabled status while scanning,
press the numeric key that corresponds with the Scan List you
4
wish to toggle. For example, pressing
while scanning will
toggle the state of Scan List 04 from enabled to disabled, or vice
versa if the Scan List is already disabled. To toggle the enabled/
FUNC
disabled status for Scan Lists 11-20, press
, then press a
FUNC 3
number key, i.e., press
to toggle the status of Scan List
13. If you enable a Scan List that has no assigned objects, the
number for that Scan List will flash in the display while the
scanner is scanning.
When you enable a Scan List, the display briefly shows the name
of the Scan List on Line 4 of the display, and the word ON or
OFF at the end of Line 3 to indicate if the Scan List was toggled
on (enabled) or off (disabled).
When Scan Lists 1, 2, 3 and 16 are enabled, the display will
appear as follows while scanning:
To toggle a Scan Listʼs status from the Global Settings menu,
PGM
to enter Program Mode, then press the GLOB softkey.
press
SEL
At the Scan Lists: item, press the
key on the 5-way
pushbutton pad. Scroll to the Scan List you wish to change and
SEL
press the
key again, then at the Enabled: setting press the
or on the 5-way pushbutton pad to toggle the Scan List on
or off. An asterisk (*) indicates that the Scan List is enabled.
Press the SAVE softkey to save settings for that Scan List, then
press SAVE again to confirm your global changes and exit the
GLOB menu.
If you inadvertently store an object with no Scan List
mappings, the object will be placed in a special "NS" Scan
List that can be accessed using the
keys while in
Manual Mode or PGM mode. Once you scroll to the NS
Scan List, you can use the
keys to scroll to the objects
PGM
found there and edit the Scan List setting by pressing the
key, then the EDIT and CURR softkeys to see the objectʼs menu.
PSR-600 User Manual Page
59
Advertisement
Table of Contents
