Table of Contents
Advertisement
Alarm
Fav
Skywarn
EXPERT BELOW
Modulation
Atten
Delay
Delay Time
Digital AGC
Supertrack
AudioBoost
Hit Count
PSR-600 User Manual
Page
None, Chirp, Hi-Lo, Alert,
Ring, 2-Chirp, Fast Hi-Lo,
DTMF#
On or Off
On or Off
AM, FM, NFM, AU
On or Off
On or Off
1-200
On or Off
On or Off
On or Off
Numeric value
Sets the Audible Alarm for the CONV object. When
an Audible Alarm is selected, the selected alarm will
play at the beginning of each transmission on the
CONV object, or anytime the scanner stops for
activity on the CONV object while scanning.
When On, the CONV object is a member of the
Favorites Scan List.
When On, the CONV object is a member of the
Skywarn Scan List.
Modulation setting for the CONV channel. In most
cases AU will work fine. Use AM to override and
force AM modulation, FM to force FM modulation,
NFM to force narrow FM modulation.
When on, applies 20 dB of attenuation to all
transmissions on the CONV channel. Useful in
areas where interference from nearby strong
signals is present.
Controls whether a Delay is used to wait for reply
traffic after a transmission on the CONV channel.
Sets the amount of time (in 100 millisecond
intervals) for the wait for reply delay if Delay is On,
e.g., 20=2 seconds.
Controls Digital AGC function for the CONV
channel
Alternative DSP decoding algorithm. May help
reception on some systems.
Applies a 6 dB boost to audio levels when the
object is active
Increments each time a transmission is received on
the SWPR object. Global "Hit Counts" must be set
Dflt
to ON. Press the
softkey to reset to 0.
103
Advertisement
Table of Contents
