Table of Contents
Advertisement
GLOB
Parameter
Atten Mode
Global Atten
Clear Hits
Hit Counts
Dflt
ScanList
Priority
WxPri
Scan Lists
SRCH L/Outs
Clear FAV
Memory Info
EXPERT BELOW
Tune LED
Color 0-7
Qtxt1-0
Key Repeat
LCD BlinkOff
LCD BlinkOn
LED BlinkOff
LED BlinkOn
Pri Channels
PSR-600 User Manual
Page
Options
Global or Normal
On or Off
SEL
Yes or No
0-22
On or Off
On or Off
SEL
SEL
SEL
SEL
On or Off
Red/Green/Blue (RGB)
value
Text value
On or Off
1-250 x 10 mS
1-250 x 10 mS
1-250 x 10 mS
1-250 x 10 mS
0-250
Description
The attenuator reduces the amount of signal at the
receiver input. This helps reduce interference from
strong nearby transmitters. Global attenuator mode
applies attenuation radio-wide, regardless of
individual object settings. In Normal attenuator
mode, the attenuator follows the individual object
attenuator setting.
When the ATTEN mode is set to Global, this
controls whether the Global attenuator is on or off.
SEL
Press
to clear all hit counters.
Turns the hit counter feature on or off.
Sets default destination Scan Lists for new objects
and CONV Stor from Searches, Spectrum Sweeper
and Tune. Use 1-20 for "normal" Scan Lists 1-20.
Use 0 for the "ns" (not scanned) Scan List (no Scan
List mappings are specified). Use 21 for the FAV
Scan List. Use 22 for the SKYWARN Scan List.
Turns Priority Scan On or Off. Priority Scan can
also be toggled by pressing
scanning.
Toggles Weather Priority Mode on or of. Also
WX
accessed by pressing
, then
Enters sub menu for Scan List settings and status
Enters sub menu for review, editing or deletion of
search lockout frequencies
SEL
Press
to clear the Favorites Scan List.
SEL
Press
to see the current memory usage.
Activates Signal Strength driven LED when in
TUNE mode.
Sets intensity of red, green and blue LEDs. Press
SEL
to edit colors. Use keys to scroll to R, G
or B LED settings. Use numeric keys to activate
preset intensity levels for each LED, or use
keys to fine scroll intensity.
Sets QTXT (QuickText) 0-9 text. Use "$" to indicate
end of text.
Toggles key repeat mode when a key is held down
For alternating text displays, sets the display time
for the secondary display element.
For alternating text displays, sets the display time
for the primary display element.
When the ALERT LED setting for an object is set to
Flash, this is the amount of time the LED stays
turned off.
When the ALERT LED setting for an object is set to
Flash, this is the amount of time the LED stays
turned on.
Number of priority CONV channels to check during
a priority scan sampling. "0" samples all CONV
priority channels.
FUNC PRI
while
PRI
100
Advertisement
Table of Contents
