Switching Off The Projector - Panasonic PT-RQ35KU Operating Instructions Manual

Chapter 3 Basic Operations — Switching on/off the projector

Switching off the projector

3)
1) Press the power standby <v> button.
f The [POWER OFF(STANDBY)] confirmation screen is displayed.
2) Press qw to select [OK], and press the <ENTER> button.
(Or press the power standby <v> button again.)
f Projection of the image will stop, and the power indicator <ON (G)/STANDBY (R)> on the projector body
lights in orange. (The fan keeps running.)
3) Wait for a few seconds until the power indicator <ON (G)/STANDBY (R)> of the projector body lights
up in red (fan is stopped).
4) Press the <OFF> side of the <MAIN POWER> switch to turn off the power.
Attention
f When switching off the projector, make sure to follow the procedures described. Failure to do so may damage the internal components and
result in malfunctions.
Note
f For approximately 15 seconds after the projector is switched off, the indicator does not light up even if the power is switched on.
f Even when the power standby <v> button is pressed and the projector is switched off, the projector consumes power if the main
power of the projector is on.
When the [PROJECTOR SETUP] menu → [STANDBY MODE] is set to [ECO], use of some functions is restricted, but the power
consumption during standby can be conserved.
f The <MAIN POWER> switch of the projector is equipped with an overcurrent protection function. When current exceeding 25 A is detected,
the overcurrent is automatically disconnected and the projector will go into the state that the <OFF> side is pressed. Consult your dealer
when the overcurrent protection function is operated.
72 - ENGLISH
4)
1)
1)
2)
2)