[Freeze]; [Waveform Monitor] - Panasonic PT-RQ35KU Operating Instructions Manual

8) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Note
f The [MULTI PROJECTOR SYNC] setting item is common with the following menu item.
g The [PROJECTOR SETUP] menu → [MULTI PROJECTOR SYNC]
For details on contrast synchronization function, refer to the [PROJECTOR SETUP] menu → [MULTI PROJECTOR SYNC] (x page 173).
f The shutter synchronization function will operate when all of the following conditions are fulfilled.
g All the projectors to be linked are connected in a loop with the daisy chain connection. (Maximum 64 projectors)
g [MODE] on only one projector that is linked is set to [MASTER], and [MODE] on all other projectors are set to [SLAVE].
g [SHUTTER SYNC] on the projectors to perform the shutter synchronization is set to [ON].
f It is possible to set [SHUTTER SYNC] to [OFF] for the projectors that are linked but not to synchronize.
f The shutter operation by the shutter synchronization function will follow the setting of the [DISPLAY OPTION] menu → [SHUTTER
SETTING] on the projector that [MODE] is set to [MASTER].
f The operation of the mechanical shutter is not included in the shutter synchronization function.
f When the input signal to each linked projector is not synchronized, the timing of the shutter operation between the projectors may shift up to
1 frame while using the shutter synchronization function.
f The shutter function of the projector with [MODE] set to [SLAVE] can be operated individually. At that time, the shutter operation will follow
the setting of the [DISPLAY OPTION] menu → [SHUTTER SETTING] set in that projector.

[FREEZE]

Pause the projected image temporarily regardless of the playback of the external device.
1) Press as to select [FREEZE].
2) Press the <ENTER> button.
f Press the <MENU> button to release.
Note
f [FREEZE] is displayed on the screen when video is paused.
f When an image from one input terminal is displayed on multiple screens while in the four-screen display mode, the appearance may vary for
each image being paused. Set the [MULTI DISPLAY] menu → [MULTI DISPLAY MODE] to anything other than [OFF] when using the four-
screen display mode.

[WAVEFORM MONITOR]

Use the input signals from a connected external device to display in a waveform. Check whether video output
(luminance) signal level is within the recommended range for the projector and adjust.
1) Press as to select [WAVEFORM MONITOR].
2) Press qw to switch the item.
[OFF]
[ON]
3) Press the <MENU> button two times to clear.
4) Press as to select any horizontal line.
5) Press the <ENTER> button to switch the Select line to either luminance, red, green, or blue.
f Line selection items switch each time the <ENTER> button is pressed only when the waveform monitor is
displayed.
"Select line (luminance)"
"Select line (red)"
"Select line (green)"
"Select line (blue)"
Note
f Setting is also available from the [PROJECTOR SETUP] menu → [FUNCTION BUTTON].
f The waveform monitor cannot be displayed while in the four-screen display mode. Set the [MULTI DISPLAY] menu → [MULTI DISPLAY
MODE] to anything other than [OFF] when using the four-screen display mode.
Chapter 4 Settings — [DISPLAY OPTION] menu
Select this item when the shutter synchronization function is not used.
Select this item when the shutter synchronization function is used.
Does not display the waveform monitor.
Displays the waveform monitor.
Displayed in white waveform.
Displayed in red waveform.
Displayed in green waveform.
Displayed in blue waveform.
ENGLISH - 145