Table of Contents
Advertisement
23 Strap hole
Attention
f Do not drop the remote control.
f Avoid contact with liquids or moisture.
f Do not attempt to modify or disassemble the remote control.
f Do not swing the remote control holding onto the strap when a strap is attached.
f Observe the following instructions that are indicated on the caution label at the back of the remote control:
g Do not use old battery with new one.
g Do not use batteries other than the type specified.
g Be sure the batteries are inserted properly.
For other instructions, read the instructions related to batteries that are described in "Read this first!".
Note
f When operating the remote control by directly pointing the remote control signal receiver of the projector, operate the remote control at
a distance approx. 30 m (98'5") or shorter from the remote control signal receiver. The remote control can control at angles of up to ±15°
vertically and ±30° horizontally, but the effective control range may be reduced.
f If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate properly.
f The signal will be reflected off the screen. However, the operating range may be limited from light reflection loss due to the screen material.
f If the remote control signal receiver directly receives strong light, such as fluorescent light, the remote control may not operate properly. Use
it in a place distant from the light source.
f The power indicator <ON (G)/STANDBY (R)> will blink if the projector receives a remote control signal.
Projector body
Front
1 2 3 4 5 6
7
8
Rear
9
11
9
Projection direction
1
Remote control signal receiver (front)
2
Power indicator <ON (G)/STANDBY (R)>
Indicates the status of the power.
3
Light source indicator <LIGHT1>
Indicates the status of light source 1.
Chapter 1 Preparation — About your projector
1.Do not use old battery with new one.
2.Do not use batteries other than the
type specified.
3.Be sure the batteries are inserted properly.
N2QAYB001052
Caution label at the back of the remote control
7
9
12
9
Made in China
Side
9
9
10
9
13
9
16 17
4
Light source indicator <LIGHT2>
Indicates the status of light source 2.
5
Temperature indicator <TEMP>
Indicates the internal temperature status.
6
Filter indicator <FILTER>
Indicates the status of the air filter unit.
8
8
14
15
9
9
ENGLISH - 29
9
9
Advertisement
Chapters
Table of Contents
