Table of Contents
Advertisement
1.800.561.8187
JCU II Power Menu
Powering the JCU II
When the JCU II is receiving power, the Power button will
be lit amber. When the button is pressed for
approximately three seconds, the JCU II will turn on and
search for cameras on the network.
On the LCD screen, Starting, then Searching... is
shown. When a camera is found, the message changes
to Connecting..., which continues to flash until the
connection process completes and is replaced by the
camera ID, such as M400. When more than one camera
is found on the network, the JCU II attempts to reconnect
to the last camera it was connected to, or if it has not
connected to a camera, it will prompt the user to select a
camera.
JCU II Power Menu
The JCU II LCD screen generally shows the ID of the camera that is connected to the JCU II. The
various functions are accessed from a set of menus, with each menu entry selectable in the JCU II
display. When powered on and connected to a camera, pressing and holding the Power button
causes the JCU II to enter the Power Menu.
Use the JCU II joystick to scroll up and down (push fore and
aft), and select an entry by clicking the left joystick button.
When the JCU II is in the Power Menu mode, the other JCU II
buttons are disabled.
In the JCU II display, a down arrow (v) indicates you can access
additional menu choices by moving the joystick down. An up
arrow (^) indicates the last menu entry is displayed, and the
other choices must be accessed by moving the joystick up. A
double arrow indicates you can move up or down in the menu.
The Power Menu shows the following menu options:
Assign JCU?
JCU Stndby?
Camera Stndby?
System Stndby?
Global Stndby?
Calibrate JCU?
Cancel
Standby States
When finished with the camera, Park the camera from the OSD menu to keep the system ready to
use at a moments notice on a command from the JCU II. When in Park mode, the system does not
generate a live video signal.
To initiate other standby modes, press and hold the Power button. After a brief countdown, the
Power Menu is shown. Scroll down with the joystick, press the left joystick button to select an
option from the menu. The menu options available will reflect the available hardware on the
camera network.
432-0012-00-10 Version 110
www.
June 2016
information@itm.com
.com
Power
LCD
screen
Scroll up
or down
Select
camera
14
Advertisement
Table of Contents
