Operation; Powering The Tg275; Ir Camera And Thermometer - FLIR TG275 User Manual

Automotive diagnostic thermal camera

Hide thumbs Also See for TG275:

Table of Contents

Operation

The TG275 is powered by a rechargeable lithium battery. Long press the

power button (center) to switch the TG275 ON or OFF. If the TG275 does not

power ON, charge the battery by connecting to a 5V/1A rated AC wall charger

(not supplied) using the supplied USB-C cable. The USB-C jack is located in

the compartment at the top of the TG275. Do not use the TG275 while it is

charging. When the top flap is closed, the TG275 is rated IP54 for encapsula-

tion. See Section 9.2, Battery Considerations and Service for more

information.

The TG275 has an Auto Power OFF (APO) utility that switches it OFF auto-

matically if no buttons are pressed for the duration of the selected APO time.

Use the menu system (under Device Settings) To set the APO timer. See Sec-

tion 6, Programming Menu System, for more information.

Figure 5.1 Combined Thermal and Visible Image (MSX®)

1. Long press the power button to switch the TG275 ON.

2. If not already selected, choose the Thermal plus Visible Image mode in

the menu system (under Image Adjustments/Image Mode). You can adjust

the MSX® (Multi-Spectral Dynamic Imaging) alignment in the Image

Mode menu (press MENU at the MSX® image option and use the arrows

to make the adjustments; press MENU to confirm).

3. Point the camera toward the test area and scan as desired. View the cam-

era image on the TG275 display.

#NAS100009; r. AA/57810/57810; en-US

Table of Contents