FLIR 432-0012-04-00 Operator's Manual page 15

1.800.561.8187
JCU II Power Menu
• JCU Stndby?—select to power down the JCU II.
• Camera Stndby?—select to power down the camera, leaving the JCU II powered
to connect to a different camera.
• System Stndby?—select to power down the camera and the JCU II.
• Global Stndby?—select to power down all the cameras and all the JCU IIs present on the
network.
Troubleshooting Tip: If the JCU II does not have power, it may be connected to a Power over
Ethernet (PoE) switch that has not been powered on, or it may be connected to a network switch
that does not provide PoE power.
Troubleshooting Tip: If this is the first time the JCU II has been used to connect to the camera, or
if the camera was not powered before the JCU II, v Select Camera is shown on the LCD
screen. Scroll down with the joystick to select a camera to control. When the ID of the camera
appears, press the left joystick button to select it. The camera ID will blink momentarily to indicate
it has been selected.
432-0012-00-10 Version 110
www.
June 2016
information@itm.com
.com
15