Installation And Setup; Wireless Indoor Sensor; Wireless Outdoor Sensor - Youshiko YC9390 User Manual

INSTALLATION AND SETUP

WIRELESS INDOOR SENSOR

Pairing the wireless Indoor sensor with the console
1 . Remove the battery door of the sensor .
2 . Insert 2 x AA size batteries into the battery compartment . Make sure you insert them the
right way according to the polarity information marked on the battery compartment .
3 . Close the battery door. The transmission status LED will begin to flash every 1 minute.
Note:
- If you need to re-assign the sensor channel, firstly slide the channel slide switch to the
new channel that you decided, then press [ SENSOR ] key on the console, and then press
[RESET ] key on the sensor to pair the sensor with the console again .
- Avoid placing the sensors in direct sunlight, rain or snow .
- To avoid the sensor/s and console pairing failure during new console setup, please power
up the sensor/s first, and then press [ RESET ] key on the main unit
(no need on sensors) .
Placing the wireless Indoor sensor
Place a screw on the wall that you wish to hang the sensor on . Hang
the sensor onto the screw by the wall mounting holder . You can also
place the sensor on a table by itself .

WIRELESS OUTDOOR SENSOR

Your wireless outdoor sensor measures wind-speed, wind-direction, rainfall, UV index,
temperature and humidity for you .
Pairing the wireless outdoor sensor with the console
Placing the wireless outdoor sensor
Install the wireless outdoor sensor to an open location with no obstructions above and around
the sensor for accurate rain and wind measurement . Install the sensor with the wind meter
end facing North and properly orient the wind direction vane . Secure the mounting stand and
bracket (included) to a post or pole, and allow minimum 1 .5m off the ground .
1 . Unscrew the battery door at the bottom of the unit and
insert the batteries according to the polarity information
marked on the battery compartment .
2 . Screw on tightly .
3 . Once the batteries are installed, the transmission status
LED will begin to flash.
Note:
- Ensure the battery door screw locked well .
- Ensure the transmission status LED is flashing every 12
seconds .
5