Location And Function Of Parts; Camera - Sony SRG-X400 Operating Instructions Manual

Location and Function of Parts

Camera

Front
*1
*1 This is not equipped on SRG-X400/X402/201M2/X120/HD1M2.
 Tally lamp (BRC-X400/X401)
Lights up in red when a tally command is
received or the camera is selected by an
optional remote controller (depending on
the setting mode). The brightness can be
selected from [HIGH], [LOW], or [OFF] (the
tally lamp does not light up) in [TALLY LEVEL]
in the SYSTEM menu.
 Lens
This is a 20× (BRC-X400/X401, SRG-X400/
X402/201M2) or 12x (SRG-X120/HD1M2)
magnification-optical zoom lens. When
[CLEAR IMAGE ZOOM] (Clear Image Zoom) is
set to [ON] in the PAN TILT ZOOM menu, the
camera can zoom up to 30× for 4K and 40×
for HD.
CLEAR IMAGE ZOOM is not available for SRG-
X120/HD1M2.
Note
Do not touch the part around the lens when
energized.
 Remote commander sensors
These are sensors for the supplied remote
commander.
 POWER lamp
Flashes in green when the camera is
connected to an outlet using the supplied AC
adapter and power cord, or when power is
being supplied by connecting the camera
and PoE+ power supply device with a LAN
cable. The green lamp stops flashing and
lights up when start-up is complete.
The green lamp flashes when the camera
receives an operation command from the
supplied remote commander.
The lamp lights up in orange when the
POWER button on the supplied remote
commander is pressed and the camera
enters in the standby mode.
The yellow lamp flashes while upgrading the
firmware.
The orange lamp flashes when there are
defects in the camera (for instance, when
rotations of fan motor slow down or stop
etc.).
 NETWORK lamp
Flashes during initialization when the
camera is connected to the PoE+ power
supply device with a LAN cable and power is
being supplied. The lamp lights up when it is
connected to the network once start-up is
complete.
Lights up after start-up is complete if
network is connected, when power is
supplied to the camera from outlet using AC
adapter and power cord. The lamp is unlit
when not connected to the network.
The lamp turns off while upgrading the
firmware.
The lamp flashes when there are defects in
the camera (for instance, when rotations of
fan motor slow down or stop etc.).
Back
*2 This is not equipped on SRG-X400/X402/201M2/X120/HD1M2.
 VISCA RS-422 IN terminal
Connect with an remote controller (not
supplied).
When you connect multiple cameras,
connect it to the VISCA RS-422 OUT terminal
of the previous camera in the daisy chain
connection.
8
*2