Access Limit Tab; Ssl Tab (Brc-X400, Srg-X400/X120) - Sony SRG-X400 Operating Instructions Manual

Re-type password
To confirm the password, retype the password that
you entered in the [Password] box.
Viewer mode
You can select the viewer mode to be displayed after
authentication when the viewer is displayed.
[Administrator]: The user can operate all functions
including the setting menu in this mode.
[Full]: The user can operate all functions other than
the setting menu and power.
[Light]: The user can select the image size and
image (Video 1 to 3) of the live viewer.
Authentication
RTSP Authentication
Set whether the user is authenticated or not for RTSP
streaming.
When the checkbox of [RTSP Authentication] is
selected, user name and password specified in the
User tab are authenticated.
Make sure to enter the correct user name and
password to display the viewer.
As the One Shot JPEG image is displayed on the
viewer when the codec is H.265, authentication is
not performed.
Notes
• The RTSP authentication setting affects getting
the RTSP streaming on programs other than a web
browser. To prevent unspecified users from
getting the streaming, select the checkbox of
[RTSP Authentication] before use.
• When the setting is changed, RTSP streaming is
temporarily interrupted. Therefore, while you
display the viewer on another web browser, the
screen turns black for a moment.

Access limit tab

This allows you to control which computers can
have access to the camera.
Likewise, when using IPv6, security settings can
be configured for each network.
Access limit
Set an access limit to the camera.
Enable
Select the checkbox to enable the access limit.
Rule
Set rules for the access limit of the camera.
Default policy
Select the basic policy of the limit from [Allow] and
[Deny] for the computers with the network address
that are not specified in the [Network address/
Subnet 1] to [Network address/Subnet 10] menus
below.
Network address/Subnet 1 to Network address/
Subnet 10
Enter the network addresses and subnet mask values
that you want to allow or deny access to the camera.
You can specify up to 10 network addresses and
subnet mask values.
For a subnet mask, enter 8 to 32.
(For IPv6, enter a value between 8 and 128.)
Select [Allow] or [Deny] from the drop-down list on
the right for each network address/subnet mask.
Tip
The subnet mask value represents the number of
bits from the left side of the network address.
For example, the subnet mask value for
"255.255.255.0" is 24.
If you set "192.168.0.0/24" and [Allow], you can allow
access from computers having an IP address
between "192.168.0.0" and "192.168.0.255".
Note
You can access the camera even from a computer
with an IP address whose access right is set to
[Deny], if you enter the user name and password set
for the Administrator in the User tab of the Security
menu in the authentication screen.
SSL tab (BRC-X400, SRG-X400/
X120)
Configure the SSL or TLS function (called "SSL"
hereafter). The settings allow the camera to
communicate with the client computer by using
SSL.
82