Connecting The Camera To A Poe+ (Power Over Ethernet Plus) Power Supply Device - Sony SRG-X400 Operating Instructions Manual

2
Fix the cord of an AC adapter with the cord
clamper so that it does not come out.
Unlock the cord clamper and put the cord
through it.
AC adapter cord clamper
 Unlock the cord
clamper lock.
AC adapter cord
 Put the AC adapter cord through the cord clamper and
lock the cord clamper.
Note
Do not use any AC adapter other than the
supplied AC adapter. Otherwise, a fire or
malfunction may occur.
Connecting the camera to a PoE+
(Power over Ethernet Plus) power
supply device
A PoE+ (IEEE802.3at compliant) power supply
device supplies power through a commercially
available network cable. For details, see the
operating instructions of the power supply
device.
Cord clamper lock
20
Network cable
(commercially
available)
Hub with PoE+ power
supply feature
Notes
• When you supply power from a PoE+ power
source, use a network cable of Category 5e or
higher.
• When both the AC adapter and PoE+ power
supply are connected, power is supplied
through the AC adapter.
• When power is supplied from PoE+, both the
POWER lamp (green) and NETWORK lamp
(green) flash until the initial verification process
is complete (approximately 1 minute,
depending on the power supply device).
• When the network camera is powered by a
PoE+ power supply, do not route the wiring
outdoors.
• If a non PoE+ compatible device is connected,
both the POWER lamp (green) and NETWORK
lamp (green) flash, and the camera won't start.
• When you turn the power off, wait at least 10
seconds before you turn it on again.
• Use an STP (shielded) network cable.