Qos Tab - Sony SRG-X400 Operating Instructions Manual

Secondary DNS server
Displays the current secondary DNS server.
IPv6 address 1
IPv6 address 2
Displays the current IPv6 address.
IPv6 default gateway
Displays the current IPv6 default gateway.
LinkLocal IPv6 address
Displays the current link-local IP address.
IPv4 setting
Configure the IPv4 network setting.
Obtain an IP address automatically (DHCP)
Select [Obtain an IP address automatically (DHCP)].
The IP address, subnet mask, default gateway are
assigned automatically.
Note
When you select [Obtain an IP address automatically
(DHCP)], make sure that a DHCP server is operating
on the network.
IP address
Enter the IP address of the camera.
Subnet mask
Enter the subnet mask value.
Default gateway
Enter the default gateway.
IPv6 setting
Configure the IPv6 network setting.
Obtain an IP address automatically
Select [Obtain an IP address automatically].
The IP address, prefix length, default gateway are
assigned automatically.
Note
If you select [Obtain an IP address automatically],
ask the network administrator whether an IPv6
address can be assigned.
This function is not available in a multi-prefix
environment. The transmission may not work
properly.
IP address
Enter the IP address of the camera.
Prefix length
Enter the prefix length value.
Default gateway
Enter the default gateway.
Common setting
Configure the common setting for IPv4 and IPv6
network.
HTTP port number
Enter the HTTP port number. Normally select 80.
Obtain DNS server address automatically
Select [Obtain DNS server address automatically].
The addresses of [Primary DNS server] and
[Secondary DNS server] are assigned automatically.
Note
To obtain a DNS server address automatically, first
enable [Obtain an IP address automatically (DHCP)]
in the IPv4 setting, or [Obtain an IP address
automatically] in the IPv6 setting.
Ask the network administrator whether a DNS server
address can be obtained automatically.
Primary DNS server
Enter the IP address of the primary DNS server.
Secondary DNS server
Enter the IP address of the secondary DNS server, if
necessary.
Camera name (DEVICE INFO - NAME)
Name for the camera.
Up to 8 alphanumeric characters can be used to set
the name.

QoS tab

Use this menu to mark the data traffic packets
sent from the device and configure the settings
for QoS control. Rules for the types of data traffic
can be created using IPv4 address, port number,
protocol, etc. A maximum of 10 rules can be
registered.
79