Connecting The Camera To A Poe+ (Power Over Ethernet Plus) Power Supply Device - Sony BRC-X1000 Operating Instructions Manual

2
To prevent the cord of the AC adapter (not supplied)
from being pulled out, use the cord clamper to
secure it.
Unlock the cord clamper and put the cord through it.
Lock the cord clamper.
AC adapter cord clamper
Cord clamper lock
1 Unlock the cord clamper lock.
2 Put the AC adapter cord through the cord clamper and
lock the cord clamper.
Note
Do not use any cord other than the specified AC adapter
(not supplied). Otherwise, a fire or malfunction may
occur.
AC adapter cord
Connecting the camera to a PoE+
(Power over Ethernet Plus) power
supply device
A PoE+ (IEEE802.3at compliant) power supply device
supplies power through a commercially available
network cable. For details, see the operating instructions
of the power supply device.
SYSTEM
SELECT
HDMI OUT
Notes
• When you supply power from a PoE+ power source,
use a network cable of Category 5e or higher.
• When both the AC adapter and PoE+ power supply
are connected, power is supplied through the AC
adapter.
• When power is supplied from PoE+, both the POWER
lamp (green) and NETWORK lamp (green) flash until
the initial verification process is complete
(approximately one minute, depending on the power
supply device).
• When the network camera is powered by a PoE+
power supply, do not route the wiring outdoors.
When you use PoE+ for the power supply, connect the
ground wire.
24
IR SELECT CAMERA SETUP
1 2 3
1 2 3 4 5 6 7 8
12V
IN VISCA RS - 422 OUT LAN
OSD
ON OFF
MONITOR OUT LINE OUT
EXT SYNC IN
SDI 1 SDI 2 SDI 1 SDI 2
TERMI-
NATION
ON OFF
Network cable
(commercially
available)
Hub with PoE+
power supply
feature