Connecting The Camera; Connecting An Ac Power Supply; Connecting The Camera To A Poe+ (Power Over Ethernet Plus) Power Supply Device - Sony BRC-X1000/H800 Operation Instructions Manual

Connecting the Camera

Connecting an AC power supply

Connect the AC adapter (not supplied) to the AC power
supply using a power supply cord.
IR SELECT CAMERA SETUP
1 2 3
1 2 3 4 5 6 7 8
SYSTEM IN VISCA RS - 422 OUT
LAN
SELECT
OSD
ON OFF
HDMI OUT MONITOR OUT LINE OUT
EXT SYNC IN
SDI 1 SDI 2 SDI 1 SDI 2
1
Connect the AC adapter (not supplied) and
a power supply cord.
2
To prevent the cord of the AC adapter (not
supplied) from being pulled out, use the
cord clamper to secure it.
Unlock the cord clamper and put the cord through it.
Lock the cord clamper.
12V
AC adapter
TERMI-
NATION
(not supplied)
ON OFF
To power supply
AC adapter cord clamper
Cord clamper lock
1Unlock the cord clamper lock.
2 Put the AC adapter cord through the cord clamper and
lock the cord clamper.
Note
Do not use any AC adapter other than the specified
optional one. Otherwise, a fire or malfunction may
occur.
Connecting the camera to a PoE+
(Power over Ethernet Plus) power
supply device
A PoE+ (IEEE802.3at compliant) power supply device
supplies power through a commercially available
network cable. For details, see the operating instructions
of the power supply device.
23
AC adapter cord