Table of Contents
Advertisement
Quad View Mode
The Quad View Mode command allows you to change the Quad View display
mode settings. Type your command in the following format:
Command + Control1 + Control2 + Control3 + Control4 + [Enter]
Command + Control + [Enter]
Command
quad
Control
cxpy
default
For example, to set Quad View Mode you must configure the four channels, as
follows:
quad c1p1 c2p2 c3p3 c4p4 [Enter]
For example, to set Quad View Mode to the default settings, type the
following:
quad default [Enter]
Note: Each command string can be separated with a space.
Quad View Mode Command
c: Output channel, x= 1~4
p: Input port, y= 1~4
Example: c2p4
Resets Quad View Mode back to the default setting Example:
c1p1~c4p4
Chapter 6. RS-232 Operation
Description
Description
73
Advertisement
Table of Contents
