ATEN CM1284 User Manual page 60

TM
Multi-View KVMP
Hotkey
Display [A] [n]
Settings
[J] [n]
[P] [n]
[V] [n]
50
Switch User Manual
Start Auto Scan with which the KVM focus cycles from
port to port at the specified interval (n = 5, 10, 15, 30,
60, 90 seconds). The default interval is 5 seconds.
See Auto Scanning, page 52 for more information.
Set the video content for Monitor 2. This function is
only supported on the CM1284. [n] specifies the
source of the displayed video.

n is omitted (Displays the content of the focused
window on Monitor 1)

n = 1 (Always displays the video from port 1)

n = 2 (Always displays the video from port 2)

n = 3 (Always displays the video from port 3)

n = 4 (Always displays the video from port 4)
Switch to the specified (n) display mode. For more
information on display modes, See Display Modes,
page 34.

n = 0 (PoP)

n = 1 (Quad view)

n = 2 (PiP dual view)

n = 3 (PiP triple view)

n = 4 (PiP quad view)

n = 5 (PbP dual view)

n = 6 (PbP triple view)

n = 7 (PbP quad view)
Configure the EDID (n) for the KVM Switch.

n = 1 (Uses the EDID of the monitor connected to
Port 1.)

n = 2 (Uses the EDID of the monitor connected to
Port 2. This setting is supported by CM1284 only.)

n = 3 (Sets the EDID to Remix mode, with which
the Multi-View KVMP
EDID.)

n = 4 (Sets the EDID to ATEN Default which is
4096 x 2160 @30Hz for CM1284 and 1920 x 1080
@60Hz for CM1164A.)

n = 6 (Sets the EDID to ATEN Default which is
1920 x 1080 @60Hz. This setting is supported by
CM1284 only.)
Action
TM
Switch uses the optimum