Overview
The Multi-View KVMP
commands sent through a PC or a high-end controller. Note that the RS-232
serial control is only possible when the Multi-View KVMP
daisy-chained with any secondary unit because the Switch's DCC In port is
required as the communication port for serial control.
Setup
1. Connect your controller or PC to the Multi-View KVMP
Use an RJ-45 to DB-9 serial adapter (SA0141) to connect the computer's
serial port to the DCC In port of the Multi-View KVMP
shown below:
SA0141
2. Download controller software that supports RS-232 serial control and the
operating system of your controller PC.
RS-232 Operation
Switch supports system control via RS-232 serial
TM
Chapter 6
Switch is not
TM
Switch.
TM
Switch, as
TM
65