Table of Contents
Advertisement
Setting ATW-R5220/ATW-R5220DAN
Setting network
By connecting the receiver and PC, you can use the dedicated app for
monitoring or controlling with the PC.
Setting the receiver's ID No.
1.
From the menu screen, turn the control dial, select [NETWORK]
and then press the control dial.
2.
Turn the control dial, select [DEVICE ID] and then press the
control dial.
3.
Turn the control dial, select the device ID and then press the
control dial.
• The setting is complete.
Setting the IP
1.
From the menu screen, turn the control dial, select [NETWORK]
and then press the control dial.
2.
Turn the control dial, select [IP SETTING] and then press the
control dial.
3.
Select an item you want to set and press the control dial.
IP Mode
Set how to obtain IP addresses.
[Auto]: IP addresses are automatically
assigned.
[Static]: Set to use the specified static IP
addresses.
IP Address*
Specify static IP addresses.
Subnet Mask*
Set the subnet mask.
Gateway*
Set the gateway.
*This item can be set only when [IP Mode] is set to [Static].
4.
Set each item.
Setting the remote control
1.
From the menu screen, turn the control dial, select [NETWORK]
and then press the control dial.
2.
Turn the control dial, select [REMOTE CTRL] and then press the
control dial.
3.
Select an item you want to set and press the control dial.
Port
Set the IP port number.
Notification
Receive notifications from the receiver.
LVL Notify*
Set whether to include the AF and RF level
in the notification from the receiver during
remote control.
Multicast IP*
Set the address for multicast.
Multicast Port*
Set the port number for multicast.
*This item can be set only when [Notification] is set to [ON].
4.
Set each item.
Setting the log message
Set whether to send the log message to the Syslog server.
1.
From the menu screen, turn the control dial, select [NETWORK]
and then press the control dial.
2.
Turn the control dial, select [SYSLOG] and then press the control
dial.
3.
Turn the control dial, select [ON] or [OFF] and then press the
control dial.
• The setting is complete.
• Syslog is a standard for transferring log messages across IP networks. It
is used for administration of computer systems and security monitoring.
Setting automatic detection by the application
1.
From the menu screen, turn the control dial, select [NETWORK]
and then press the control dial.
2.
Turn the control dial, select [DISCOVERY] and then press the
control dial.
3.
Turn the control dial, select [ON] or [OFF] and then press the
control dial.
• The setting is complete.
Setting NTP
Set the NTP (Network Time Protocol).
1.
From the menu screen, turn the control dial, select [NETWORK]
and then press the control dial.
2.
Turn the control dial, select [NTP] and then press the control
dial.
3.
Select an item you want to set and press the control dial.
NTP
Server adrs*
Port*
Time Zone*
DST*
DST Start Date*
DST Start Time*
DST End Date*
DST End Time*
*This item can be set only when [NTP] is set to [ON].
4.
Set each item.
21
Set whether to enable or disable the NTP
(Network Time Protocol).
Set the NTP server address.
Set the NTP port number.
Set the time difference from the UTC
(Coordinated Universal Time).
Turn on/off the daylight saving time.
Set the starting date of daylight saving time.
Set the starting time of daylight saving time.
Set the ending date of daylight saving time.
Set the ending time of daylight saving time.
Advertisement
Table of Contents
