Setting Devices - Audio Technica 6000 Series Manual

3.2.2 Setting devices
Setting a hub or router with DHCP server
Setting ATW‒R6200 S
Setting PC (Windows)
(Note) If you want to automatically assign IP addresses in the LAN, you should enable
the DHCP server on either the ATW‒R6200 S, or a hub or router with DHCP server.
■ More than one DHCP server should not exist in a LAN. The following table describes valid
configurations for the DHCP server.
■ If you use the DHCP server on the ATW‒R6200 S or all the device settings use static IP
addresses, a hub without the DHCP server function may be used.
PC
Pattern DHCP
1 server
Pattern DHCP
2 client
Pattern DHCP
3 client
*1 For Auto IP on ATW‒R6200 S, see "Obtain an IP address for ATW‒R6200 S
automatically".
*2 For DHCP client on PC, see "Configuring DHCP client".
*3 DHCP client and Auto IP may be set as static IP addresses.
Hub or router with
DHCP server
‒
DHCP server
‒
ATW‒R6200 S
Second or
First
subsequent
installation
installation
Auto IP Auto IP
Auto IP Auto IP
DHCP
Auto IP
server