Setting Method For Mix Mode Switch (Atcs-M60A Only); All Finish From Chairperson's Microphone - Audio Technica ATCS-60 Instruction Manual

6.6. Setting method for MIX MODE switch (ATCS-M60a only)

MIX MODE should be set to ON when microphone units that perform automatic mode operation
and microphone units that perform manual mode operation are used together.
* When this function is not used, turn the setting to OFF to prevent erroneous setting.
* Set MIX MODE while the power supply to the microphone unit is turned off.
* When the power supply to the microphone unit is turned on while the MIX MODE switch is set to
ON, the light ring LED lights.
1. The MIX MODE switch is located on the bottom of the microphone unit.
2. Set the MIX MODE switch by using a small-sized screwdriver (refer to the setting example shown below).
3. Through a combination of the MIX MODE setting and the setting of the master control unit or
Conference Manager, mixed operation can be performed.
MIX MODE
setting
* Note that only when the priority microphone is set and the MIX MODE is set to ON, is the operation
mode the inverse of the mode that is set on the master control unit/Conference Manager.
6.7.

All finish from chairperson's microphone

When the priority microphone is set, it is possible to suspend the speech and speech-request
functionality of all microphone units other than the chairperson's by holding down (for 2 seconds
or longer) the TALK button on the chairperson's microphone unit (ID 001).
Prohibition of speech from all microphones is lifted.
Setting of master control unit/Conference Manager
Priority
microphone unit
Automatic
OFF
ON
Manual
AUTO
Non-priority
microphone unit
Automatic
Automatic
P27
MANUAL
Priority Non-priority
microphone unit microphone unit
Manual Manual
Automatic Manual