Audio Technica 5000 Series User Manual page 7

Part names and functions
Rear panel
The figure below is ATW-R5220.
❶
❶
Antenna input jack
( : Symbol indicates direct current.)
Each jack supplies DC12 V to a connected antenna.
Additionally, other compatible antenna accessories (sold separately) can be connected.
❷
Antenna output jack
Distributes and outputs signals input to antennas A and B.
By using this jack, it is possible to connect up to seven receivers (eight total).
❸
Ground lift switch
This switch isolates the GND pin of the balanced/unbalanced output from the ground.
Normally this is kept in the GND position, but if a hum develops due to a ground loop, switch to the LIFT side.
❹
Balanced output jack (XLR 3-pin male)
GND
❺
Network interface
By connecting to a PC via Ethernet, you can use the PC for monitoring or control.
In the case of ATW-R5220DAN, this can also double as a DANTE output terminal.
LAN : 100Base-TX
DANTE : 1000Base-T
❻
AC inlet
Connect the power cable.
(～: Symbol indicates the current.)
❼
Main power switch
Press to turn the power on/off.
❷ ❸❹ ❸ ❹
HOT
COLD
❷ ❶
6
❺ ❻ ❼