Table of Contents
Advertisement
How to operate
Basic operation
1.
Turn on the main power button of the receiver
(ATW-R5220/ATW-R5220DAN).
2.
Turn on the power button of the receiver
(ATW-R5220/ATW-R5220DAN).
• The display lights and the main screen is displayed.
3.
Set the operating frequency.
4.
Turn on the power switch of the transmitter
(ATW-T5201/ATW-T5202).
• The indicator lights and the display shows the main screen.
ATW-T5201
5.
Set the transmission frequency.
6.
Check the RF level indicator on the receiver.
• Check that antenna A or B lights up.
7.
Speak into the microphone.
• Make sure the AF level indicator lights up on the receiver.
• Hold down the DOWN button of the transmitter (for ATW-T5201, turn the
lever push switch to the DOWN side (left side) and keep it there) while
turning on the power switch to start up with the RF output in the OFF
state (RF OFF mode).
ATW-T5202
Using IR SYNC
This function allows you to make settings on the receiver that are
specified for the transmitter.
1.
When IR SYNC is started as part of setting the receiver, the
"Communication in standby" screen is displayed.
2.
Position the IR SYNC windows of the receiver and transmitter so
they face each other.
3.
Press the SYNC button on the transmitter.
• Wait several seconds until communication is established.
4.
When the SYNC is complete, the "completed" screen is
displayed.
• The settings made on the receiver are automatically synced to the
transmitter.
• If an error occurs in the SYNC process, an error screen opens and then
the display returns to the menu screen. Check the IR SYNC windows of
the receiver and transmitter and then SYNC again.
• To cancel the SYNC process, press the BACK button on the receiver. You
will be returned to the previous screen.
Using SYNC shortcut
SYNC shortcut allows you to easily move to the settings screen where
you can configure the transmitter settings from the receiver.
1.
Press and hold (for approximately 2 seconds) the control dial on
the main screen.
2.
"TX SYNC" setting screen is displayed.
• Refer to "Setting transmitters via IR SYNC" (p. 17) for subsequent
steps.
14
ATW-T5201
ATW-T5202
Advertisement
Table of Contents
