How To Operate The Basic System - Audio Technica ATCS-60 Instruction Manual

10.
[Setting of microphone unit]
1. Set the microphone ID. (Refer to section 6.5 "Setting the ID switches" )
2. Set the MIX MODE switch. (ATCS-M60a only) (Refer to section 6.6 "Setting method for MIX MODE
switch (ATCS-M60a only)" )
3. Turn on the power supply to the microphone unit.
* We recommend that you turn on the power supply to the microphone unit first and then turn on the
power supply to the master control unit.
When the power supply to the master control unit is turned on first, the microphone's light ring LED
flashes and the microphone unit remains inoperative for approximately one minute.
Using the MODE selector switch ((i) in the figure), select automatic mode (AUTO) or manual mode (MANUAL).
Using the PRIORITY switch ((ii) in the figure), set the number of speaking microphones and the number of
priority microphones.
Use the left switch to set the number of speaking microphones (from 1 to 5).
Use the right switch to set the number of priority microphones (from 0 to 4). When manual mode has been
selected, use the right switch to set the FIFO/LIFO operation.
Set the voice detection level of microphone units with the THRESHOLD switch ((iii) in the figure). When manual
mode has been selected, this step is unnecessary.
Set the length of time that a microphone will remain on without receiving sound input by using the HOLD switch
((iv) in the figure). When manual mode has been selected, this step is unnecessary.
Press the SET button ((v) in the figure) for 2 seconds or longer, or turn the power supply to the master control
unit off and on again, to complete the setting.
* To operate the system in the preset mode, set the PRIORITY switch to "99" and the TEST switch to any
number from 0 to 8.
MASTER CONTROL UNIT
ATCS-C60a
MASTER CONTROL UNIT
ATCS-C60a
(front view)
P38
(Rear face)
(Front face)